Off Highway Vehicle Forum - ATVs | Dirt Bikes | Snowmobiles | Watercrafts

Off Highway Vehicle Forum - ATVs | Dirt Bikes | Snowmobiles | Watercrafts (http://www.allohv.com/index.php)
-   Yamaha ATVs (http://www.allohv.com/forumdisplay.php?f=8)
-   -   Raptor 350 Carb rebuild (http://www.allohv.com/showthread.php?t=54)

jschrock 10-11-2010 02:16 PM

Raptor 350 Carb rebuild
 
Well looks like I will be rebuilding the carb to the wife's 350, I think the pilot jet is clogged. It will not stay running and pops/crackles for the short time it does run.

I will post pics of the rebuild and what it looks like inside.

jschrock 10-11-2010 02:17 PM

Reserved for pics

jschrock 10-11-2010 02:17 PM

Possibly another spot reserved. Hope to start on this tonight, might be tomorrow though.

eddiefromcali 10-20-2010 02:37 PM

waiting on pics...did you get a rebuild kit or just gonna clean it up and stuff?

chevyrado14 11-11-2010 10:36 AM

did you get it running? im having a hard time with my big bear. it sat for a while and the carb got gummed up. I took it all apart and cleaned all the jets. it still wont run without the choke on. Any ideas?

eddiefromcali 11-12-2010 12:07 AM

When I rebuilt my carbs, I left them soaking in this bad boy, rinsed in fuel, blew out all the passages and it was good to go. But it sounds like either a jet is gummed up or the needle seat is dirty.

http://www.berrymanproducts.com/Port...shots/0996.gif

chevyrado14 11-12-2010 08:56 AM

i actually figured it out. my pilot jet is completely blocked. i have a rebuild kit coming.

chevyrado14 11-17-2010 05:55 PM

got the pilot jet replaced and got my big bear running smooth again. From now on im shutting the fuel off and running it til it runs out of gas when i know im not gonna be riding a while.

nosbusa 01-31-2013 02:14 AM

all this reserving, and nobody is at the table.....




aaron is my bitch


All times are GMT -4. The time now is 07:25 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.